Posted by JD Seller on October 20, 2018 at 19:10:24 from (208.126.198.213):
In Reply to: australian cattle dog posted by chuck machinist on October 20, 2018 at 16:36:26:
A couple of things to think about.
1) IF you do not have a lot of room a working dog will be trouble. They are smart and need to be active. They will find something to keep busy with if you do not work with them. Any working dog is NOT a good choice for a dog if your going to be gone all day and they have to be tied or in a kennel. On an acreage or farm they are fine. They need to be active.
2) I have only been dog bit twice in my life. Both times it was dogs I had been around before and never had any issue with. They both where heelers. The one was getting older and nipped my hand really hard when I was petting him. I needed 20 stiches on that one. The other bit me as I walked passed some shrubbery on a side walk. He was under the bush and snip my pants/leg as I walked passed.
So I keep an eye on any heeler type of cattle dogs. They are active and very family loyal. Not the best if you have lots of strange people around.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
