Posted by newhollandnut on October 20, 2018 at 21:07:05 from (174.231.166.46):
In Reply to: Welding posted by TDJD on October 20, 2018 at 13:44:28:
I have burnt an enormous amount of rods and been paid for it but I am in no way shape or form a welder. 90% of my welding experience is steel casing pipe for water and sewer bores from 24”-60”. I did not consider that welding because it was limited variables and always the same products. That said one piece of advice that I got that I still use a lot to this day on things of my own and things that need to be good is making “practice runs” either leave the welder off or unhook the ground lay a pretend bead on what you want stuck. This gives me a good feel for positioning and speed. It’s easy to do with mig because you don’t have to keep getting closer as the rod burns. Just practice practice practice. I’ve seen guys that have been through welding classes that can barely stick metal and I’ve seen self taught guys that can weld more pretty than a machine. Just practice and don’t be afraid to ask for advice
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
