Aint Dat Da Tooth! Fell two weeks ago and had ex rays on my left shoulder Friday that the doctor ordered Monday. Not much sleep all week but still had stuff that needed to be done. Weekends I have to work with horses and try to repair a thing or two. I got the plug out of the pan on old ugly and the oil drained out. Thar it sets. I needed to tie the five stallions out to keep them obeying commands. I had skipped a couple weeks so didn't think I should skip another. Rained Saturday so went out Sunday about noon. The horses were mud balls Sunday from Saturday rain and I wanted to try the new settings on my new camera. Still not correct I found out. The tractor tire tube I had the tire shop patch was down. I pulled the tube back out to take back for them to find out why. I think I will still follow some advise and pick up a new tube. Got a little more sleep last night. Only had to set on the edge of the bed twice in the night to let the pain level to get to where I could lay back down. I have a mold at the factory on the mill that I should get at today. Doctor is suppose to call on my shoulder today for the next step. Old just sucks! Any way here is what video I took yesterday of the horses coming up to the fence to get tied. I have to have them all tied or they can push by when the gate is open with me in the wheelchair.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
