Posted by ggb3 on November 17, 2018 at 06:44:28 from (174.126.108.182):
In Reply to: YTDOT posted by John in La on November 16, 2018 at 15:52:47:
Quoting Removed, click Modern View to see
Please excuse me for not following directions on this response (no comment on the ticket)...... In-short, I would raise it on cribbing and secure it side to side and fore and aft. I will leave the rest for others to reply. I come across the picture below and used it as a teaching moment for possible consequences of unsecured loads. From what I understand, everyone walked away. I think some of these pictures should be at the loading area of Lowes and Home Depot to remind folks.
Hope the picture loads. Hopefully I am not stealing a post, the picture is a sheet of plywood and yours is of plate steel, which the steel would have an exponential amount of energy over the ply....
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
