Posted by fixt on December 03, 2018 at 05:00:21 from (50.111.21.158):
In Reply to: Best new chainsaw? posted by modirt on December 02, 2018 at 07:26:11:
My ex paw in law was an arborist in MS, we used McCullochs back then until they started on the plastic stuff and then he swapped to Stihl. He had lots of 10-10s and a 1000. Huge and heavy but man did that thing have the power to cut through the big stuff. My first saw was a 7-10 built out of a box of junk parts and that was a great saw. Someone else thought the same thing and stole it.
He impressed upon me that the key to longevity was to measure your mix and keep the air filter clean. That has served me well on my old 034 super. It still starts 1st or 2nd pull. It's probably 30 years old now and shows no sign of giving up. I also have a Jonsared turbo smaller saw that was given to me. Its a lot harder 1st start but cuts well and starts easier after that.
The best saw is the one with local dealer support. I see a quite a few of a brand called Redmax used by cutting crews. Good looking saws but I have no direct experience with them. No idea who makes them for sure, Husqvarna I think.
Use no ethanol trash. It's for drinking, not fuel. Measure mix and keep the air filter clean. It works.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
