Posted by caterpillar guy on December 06, 2018 at 15:05:01 from (47.26.86.124):
In Reply to: Movin' BIG bales posted by OregonAaron on December 03, 2018 at 08:40:19:
If you have a truck frame, if you had a hoist. You could with the tractor pull from under the end of the bale, till you get a balance point on the bale. Back your truck frame under the end then finish pushing/ pulling the bale on to the truck bed when home can tip the bed up to dump it off. Repeat with next one. You might even be able to put 2 side by side on there. Do you have to get them home or are they at your place? Would make a big difference on the flaking them off to feed. If you decide to flake the hay off and have to haul it you need to cover it or it will all blow away by the time you get home to feed it. If you need to haul them home I would just hire that done then feed them from there. Time fooling with them and hauling will cost as much as the savings. Most guys that can haul them would be able to load them. Or you could hire somebody to load them for you to haul.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.