I had been in the Canadian work force, for a period of four years.The USA was, and still is Canada's biggest trading partner. From time to times these two nations (USA & CANADA)lock horns and disagree on various trade philosophies and principles. When a nation "CANADA," has only 1/10 the population of our neighbour "USA" trade slow downs, and or stoppages, or trade problems sent to the world court, can cause a lot of discomfort for both nations. I remember all to well, the Government of CANADA did try to educate Canadians,at least in some demographic locations that Canada must look outside NORTH AMERICA for trading partners. Those nations whom were interested in Canadian goods, did indicate Canadian goods would have to have a METRIC identification on such goods. As I was employed in the Transportation of Natural Gas to our neighbour "USA", the entire Natural Gas Pipeline infrastructure, Compressor Stations and Prime Movers maintained the Imperial system of weights and measures. Was it a good thing that Canada adopted the METRIC SYSTEM? Was it a MISTAKE that CANADA adopted the METRIC SYSTEM? A Democratic Nations Government should have to do what the elected citizens ask of their Government. As a Canadian, I would ask myself, "has the implementation of Metric been good for Canada in the realm of trade"? The entire Planet is in one hel_ of mess with trade issues. I believe time shall prove that going Metric was a good thing for Canada. 7 billion + citizens on this plant. If Utilizing Metric can gain footholds into more trade ,then so be it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
