Tractor Talk Discussion Board |
Re: Crank Starting
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Carp on August 07, 2001 at 01:33:24 from (12.27.55.243):
In Reply to: Crank Starting posted by Josh Goicoechea on August 07, 2001 at 00:17:02:
I have a few tips. Only crank in 1/2 turns. Do not try to spin it all the way over. Pull up on the crank. Engage it on the bottom and pull up 1/2 turn. Be careful not to wrap your thumb around the crank like your holding a bat or a golf club. Keep your thumb on the same side as your fingers. Don't hold onto the crank any tighter than you have to. If the engine kicks back, you want it to pull out of your hand, not your sholder out of its socket. As far as throttle settings and choke, every tractor is different. My Farmall A for example starts like this. 3 cranks 1/3 throttle no choke. Normally starts 9 times out of 10. If not. 1 crank with choke and then crank without choke. Starts every time. One last piece of advice. If you have a JD, just buy a Farmall to pull it, it would be a lot easier.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|