Here's some pictures to show the cost of Fasteners approved for AERO Applications...and why the proper / best tool is used:
These Fasteners can be subjected to operating conditions of 1000F > 1500F> and at times under full power of 15,000>18,000 hp higher temperatures develop.
Typically the exotic alloys used in these Bolts / Nuts can account for a SPLINE NUT,28 TPI costing... Minimum ...$25.00 > + per nut:
With proper training and a SNAP-ON SPLINE wrench,I've removed and Installed the same set of Gas Generator to Power Turbine fasteners many many times:
Same is said for the internal fasteners (areas of intense heat)on these four classes of gas Generators:
Rolls Royce Gas Generator... Model..."SPEY" General Electric ....Model LM1600 General Electric.....Model LM1500 General Electric.....Model LM2500
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
