Posted by RBoots on January 12, 2019 at 21:58:54 from (173.241.113.101):
Too bad I can't take it home! This is some of Friday's work. We had a spot along a road that had a bunch of dead ash hanging over it. We have a small crew, but we plug away across the county trying to remove the dead and dangerous trees along the roads, while also trying to keep the normal right of ways cut back. This whole job was about a quarter mile long, and this might not look like much wood, but this pile alone is about 150' long and the wood is piled about 2-3' deep in places. We cut most of the pieces about 30" long so if someone was to pick them up, it would be a little easier for them. We aren't in the business of cutting firewood though, although we like it when people pick it up so we can mow the roadsides back a little easier. We ran the tops and anything up to about 8" through the chipper, except stuff that had so much poison ivy in it we don't dare touch it. I currently have poison ivy in 5 different spots from 3 separate days of cutting in areas with a lot of poison ivy. While we were there we trimmed any limbs hanging below 16' that stuck out past our tree line, just to keep that stuff back too. Only machinery involved was a pickup and chipper, chainsaws and gas powered pole saws. Hopefully this wood will disappear soon! Then I went home and cut a pickup load of wood for my shop, but my wrist is bugging, so it was time to hang it up for the day.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
