Posted by RedMF40 on January 20, 2019 at 09:44:08 from (172.58.184.161):
In Reply to: School Bus Chassis posted by modirt on January 19, 2019 at 15:43:01:
Sounds like a fun project, maybe more time-consuming than you'd planned. I also image the resulting mess is going to leave a pretty big footprint, so I'd plan to have a big area in which to work safely.
I remember visiting relatives north of Detroit as a kid, taking the highway through the motor city and marveling at all the new vehicles and variations on that theme. I especially liked the bare-chassis trucks destined to be school buses or straight trucks or whatever. Had never seen that before.
For the remark about scrapping buses, I've seen Baltimore's city buses piled about five high at the scrap yard where I've taken my metal in the past. Sometimes 20-30 of them at a time--looked like the buses were just taken off the streets and sent to the crusher. Hard to believe they didn't have any more value than that.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
