Tractor Talk Discussion Board |
Re: 10 ft bladed pull behind grader:anyone know something about them?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rennie on August 27, 2001 at 06:39:25 from (209.23.99.206):
In Reply to: 10 ft bladed pull behind grader:anyone know something about them? posted by solates on February 18, 2001 at 05:21:37:
In upstate NY we have the York Rake Co. In Unadilla, NY, always painted yellow, in business since the horse drawn era, they built the "Workman" and "General Workman" in later years, which our town still uses one of, seperate engine and hydraulic control, although they made the mistake of getting rid of the 1961 ACRS Walter truck they pulled it with just before the Blizzard of '93. Another Upstate producer was the Good Roads/Champion outfit in Marathon, NY, and the Acme Road Mach. Co. which was an offshoot, in Frankfort, NY, that also built rollers. The style of framework can give you clues,(Russell used a flat channel steel frame on horse drawn models, sort of rectangular but with distinctive rounded corners, I think our town had a couple of those and a "Mammoth Leaning Wheel" Adams or Austin? with an arched frame, as the town was originally divided into "wards" each with a "warden" who was boss, and farmers could pay their town taxes by working on town roads with their teams pulling graders, etc. Our town would pull three graders c. 1920 with their Linn tractor, doing the center and both ditches at the same time). If there is no manufacturer's plate or name, you will probably have to just use comparison to figure out what it is. If it came from a local highway dept. you might be able to research their records, any purchase of equipment was usually recorded in the minutes of town meetings, etc. I think York typically had a large hand wheel either side of where the operator stands and 3 smaller wheels in front, and a flat frame.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|