When my son first started driving on his own when he was about 14 or so, he was doing some discing. It was a wet year so I had showed him how to work around wet spots by circling around and getting closer til it was wet, then leave the rest. He did fine til the second day. He came to me in another field and said he was stuck. We went to look and there it was, at least 50' into the water and cat tails. You could see where he had done right by circling to the right spot, but then for whatever reason he decided to make a loop in the field and hit it dead center. We are talking about a couple acres of water. How he got that far in I will never know. He couldn't explain either. Still today he says he doesn't know why he did it or how. Had to hire an excavator to pull it out.
The same year he had to go to a field that was further away. I took him and showed him where it was and he said he could find it. So he left for that field and I left to Finnish planting another. A couple hours later I get where he should have been, but he's not there. So I go looking for him. Looked for maybe a couple hours and never found him. Was just getting ready to report it to the police when he comes in the yard. He got lost and couldn't find his way home til somehow he got to town. The big thing is that the cylinder on that disc leaked down slowly, but he didn't notice, so the drag on the back had been dragging on the road. It was a spike tooth and he wore off about half the spikes. Couldn't even be mad either time because I had left him alone. Makes a good story tho. Lol
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
