Posted by JD Seller on January 27, 2019 at 08:45:10 from (208.126.198.213):
In Reply to: Implement trailer? posted by GEO-TH, In on January 27, 2019 at 05:49:52:
George the reason your current trailer "slaps" the ball is that it is not heavy enough on the hitch when empty. Many short trailers have this issue. I have just added some weight to the tongue to stop the slap. Usually a few hundred pounds will cure the slap. I used an old combine rear weight. The weight was "T" shape so four of them set perfectly between two angle irons across the tongue frame.
Also tilt trailers are really bad about this if the entire bed tilts. They have to have the axles so far forward that the trailer is almost balanced.
I have a two Big Tex tilt bed skid steer trailers. They pull very well and do not "slap" the ball when empty. The key is they have a tilt section and a flat section in front of that. This allows them to use a shorter tilting section. This makes the trailer be better balanced when empty. The tilt is manual. The weight makes it go down. You can easily just walk up the trailer and your weight will make it lift up to flat.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.