Posted by moresmoke on January 29, 2019 at 16:14:25 from (216.196.78.94):
In Reply to: Miller 250D posted by Jims on January 29, 2019 at 12:47:53:
Portable engine drive welders like this commonly don’t have leads with them. The leads are a bit too portable and tend to wander off if not kept locked down.
For all practical purposes, this is a stick welding machine. Yes, you can add MIG and TIG capability, but those are added cost options. A voltage sensing wire feeder will cost you $600 plus. You can scratch start TIG relatively cheap, but it is not something most people will use.
I have a Trailblazer 302 that I use for all my welding. A portable does not make the best shop welder, but has certain advantages. Like being able to power the house during a power outage.
Running and working, that unit would probably bring $3-4000. So $1000 is not out of line if it runs and is untested. But is still a risk.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
