Posted by Christopher S. on February 02, 2019 at 13:25:47 from (71.50.52.137):
Good Afternoon Gentlemen, a few months ago we had a power outage that lasted several days. We decided to setup our house to run the essential items off of a portable generator. All seemed to be well until we tried to fire up the furnace and we received the error code b6: Blower over/under voltage or over temperature trip. While on generator power, I used a multi-meter to check the voltage and it read 126 volts. I flipped back over to power company power and the furnace fired right up. I checked the power company power voltage with a multi meter and it read 124 volts. Is there something I could install before the furnace that would clean up the power to allow the furnace to run? We just installed an identical setup in my parents house the previous weekend and everything worked fine. The only difference is his furnace is about 20 years older and has a lot less electronics.
As a side note, during the power outage a few months ago I tried running my furnace off of a yamaha inverter generator and was only able to get the furnace to run one time. I kept getting an improper grounding fault code. My parents furnace had no issues whatsoever running off a pair of honda inverter generators.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.