Posted by 2510Paul on February 05, 2019 at 10:32:20 from (72.160.248.225):
In Reply to: Gas line measurement posted by 2510Paul on February 05, 2019 at 09:06:25:
The one going to the house has no riser on either end. The one to the shed does.
The pipe outdoors to the house is 68' long, then there is about another 20' of 3/4" steel.
I just noticed that one of the tables Steve@Advance referenced showed 0.622" I.D. for a 1/2" Natural Gas line. That would be very close to mine, if not exact. This table was setup for 2 PSI or less at the inlet. I am at 2 PSI per the Gas Company.
If I have this all right I can only support 50-55,000 BTU/hr., I need 80,000. So, I am under sized.
If anyone thinks I did this wrong let me know. Looks like a summer project. I am confirming with the Gas Company.
Lucky I have a backhoe on my Compact Tractor. This lead to a tractor project after all.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
