Tractor Talk Discussion Board |
Re: Re: Re: Ford 2n Starting Problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Leon on September 23, 2001 at 11:52:02 from (207.254.193.43):
In Reply to: Re: Re: Ford 2n Starting Problems posted by tractorless on September 22, 2001 at 17:51:32:
As a old retired mechanic, I found the rubbing block on new points has to wear in. It will do this in just a short while and close the point gap 1 to 2 thsnds. Therefore I usually set my gap a little wide and let it wear to correct gap. This also changes the timing somewhat so really the best way is set it correct to start with and re set the gap after a few hrs running. I set the wider gaps on units I might not see again for awhile. If you don't do one of the above the points will pitt when they wear & close up.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|