Posted by DoubleR on April 04, 2019 at 06:15:40 from (198.105.230.180):
In Reply to: Travel trailer/camper posted by pburchett on April 04, 2019 at 05:23:17:
I have a 04 Rockwood 30ft fifth wheel I purchased in 05, it was used one year, it has one slide out. We put about 2,000 miles a year on it. The rear of the camper came lose from the frame in about 07. I paid some camper repair place 500 bucks to do a repair that lasted about 2 years. I then made a couple a braces that seem to be still keeping it in place. Although after I purchased it I had a guy weld up a trailer receiver on the back and it may have compromised it, not sure.
I have never left the state of Michigan with the trailer and would be scared to do so. It would be junk before it made it to Alaska I do know that. We do keep up the maintenance on it and have sealed the roof once.I've replaced the tires three times on it. The original tires blew out one by one. I called Carlyle tire and they sent me a whole new set of free tires. The original tires were not even rated to carry the weight of the camper. It has never leaked and everything else has held up other than the rear end. I've looked at allot of them and they are all built about the same way. One guy said my trailer probably went down the line on a Friday afternoon hence the rear end problems.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
