NOTE " If you hook the gauge directly to 12V power you can let the magic smoke out of it FAST"
If you measure the voltage YES you you see it toggle from 0 to 12V. its spose to "The gauge uses a 5 volt pulse supplied by the instrument cluster's voltage regulator".
Its a switch to get an average of 5V it toggles from 0 to 12V if it were on for a second and off for a second the average would be 5 to 6V that is the 5V supply the gauge uses..
If you want to go deeper start a post on your issue... I hope those that don't understand how a Ford system with a voltage stabilizer works set back and be quite... Its somewhat of a different animal...
Google how does the voltage regulator work on a ford fuel gauge
Yes it took me awhile to get a grip on it I took the cluster out and wired it to a sender on my work table using a voltmeter it threw me a curve ball :(... I them hooked a DSO on it and saw the light :) The DSO scope showed me voltage over time not an average jumping around you will see with a DVOM... IF no DSO use a analog volt/ohm meter then you can see the needle swing back and forth...
If the voltage stabilizer is switching its working one thing to remember the base of the VR MUST BE GROUNDED It may be best to run a dedicated ground to it :wink: :wink:
I call those old ford car/truck dashes Gillette dashes they are all metal and have hidden razor blades you are gonna bleed if you would on them much...
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
