The temp is so specific at the failure point that I would be looking at the coolant temp sensor also. If it goes open or shorts could make it die out. I would think you could restart it though, and it would likely run poorly after the restart. Crank sensor maybe, but I would think it would need to be hotter to fail that, and would be more random or variable IMHO. It will run pretty much normal with the MAF sensor unplugged so I would run it through a warm up cycle with it unplugged. Also you can tap on the MAF and tug on the wires and watch for stumbles. Some have the IAT integrated into the MAF also so I would watch that reading also just for the heck of it, although I cant see that alone stalling her out, but could point you to a bad MAF. That is , if it isn't separate like in the air cleaner housing. A good scan tool should be able to catch what is happening. I had an 06 Buick once that was cutting out like that, that one was the PCM, likely bad solder joints . But that one wasn't as predictable like you said this one is at 155 degrees.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
