|
Tractor Talk Discussion Board |
8n runs rough and smokes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gary on November 23, 2001 at 18:30:43 from (209.23.132.20):
I have a 48 8n that I have been trying to repair without much sucess. Originally, it ran very rough and high degree of smoke from the exhaust. I had new valves and seats installed. still same. Installed new rings and oil ring plus rod bearings. still same. can't get carb adjusted for low idle. install rebuilt carb. new plugs and points, new manifold and gaskets. Still the same. runs rough mostly on low idle and smokes. Just took head back off and finding excessive oil on piston tops. Where is it coming from? Check the crank and cam shaft gears for mesh and play. Seem to be tight. Hope someone can give me some tips on where to go next.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
