|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Farmall A model Throttle linkage.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on November 26, 2001 at 20:53:43 from (128.59.58.120):
In Reply to: Re: Re: Re: Farmall A model Throttle linkage. posted by big fred on November 26, 2001 at 18:35:02:
Try pulling the link pin that connects the governor rockshaft (on the carb side, it'll be secured with a cotter pin, a bent nail, or a twisted wire) to the turnbuckle (the threaded fork) on the front end of the rod that connects the rockshaft to the carb. What you are trying to determine is if the rockshaft will move when disconnected from the carb. (This way is usually easier than trying to disconnect the back end of the rod from the carb throttle lever.) If the rockshaft DOESN'T move, then the problem will something like Big Fred described, and you'll have to go into the governor,which isn't as frightful or intimidating as it sounds. If the rockshaft DOES move (there will be some resistance from the springs in the governor) then the problem is more likely with the carburetor, especially if the rod to the carburetor doesn't move or is sticky. If the rockshaft DOES move, AND the rod to the carb moves pretty freely, try the adjustment I described in the earlier post. In any event, Big Fred's recommendation that you get your hands on a Service Manual (one book covers the A and the B/BN) is a good one, for all the little problems like this that pop up with these fine machines. By all means, keep us posted! There's a lot of folks here can offer the help you need to get things running right again.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
