Hi, you said ground was sloping to the left, the hydraulic suction filter is on the right front of the seat just above the top of transmission cover, so yes if hydraulic reservoir is low in hydraulic oil then the suction filter could have sucked air. There is only the one hydraulic reservoir under the seat and filler plug is a pipe plug behind the seat onto of the reservoir. Look down thru the filler hole and you will see a short of shelf, full level is when shelf is covered.
If it has an IH 2000 loader on it, it may a modified hydraulic system to use the trans/diff as an aux hydraulic reservoir for the loader. You can tell if it has this modification by lifting the seat and if there is a flat plate with two hydraulic lines connected and if it has a hydraulic pump mounted out in front of the rad then it has this modification and the trans/diff has to be filled with Hytran hydraulic oil as well as the reservoir under the seat.
You may have trouble getting the hydraulic pump to prime so back tractor back up the slope and make sure front wheels are pointing down the slope so the hydraulic oil will run to the pump in front of the engine and prime itself.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
