Posted by old on June 30, 2019 at 12:32:56 from (67.142.112.88):
But it is one I have welded together a time or to. They keep braking about 4-6 inch from the pitman ball mount and not in the same place as the weld. Still not able to figure out why they keep breaking. One thing I know that is not helping it the ledger plate on the other most guard is missing. It is the big guard that is at the end of the bar that has the swather board on it. So are all those guard the same?? I have one that was on a Ford 515 sickle bar mower that is good so if there the same I'll swap it out and see if that helps. I'm getting good at changing the bars. Did in in less then 10 minutes yesterday and installed the new bar I had just rebuilt that has no welds on it and all new section. Mowed for 1.5 hours yesterday came in to cool off then went back out to mow the rest of the front field and got maybe 2o feet when the bar broke.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
