Posted by JD Seller on July 26, 2019 at 22:15:16 from (208.126.198.213):
In Reply to: JD baler adventure posted by Grandpa love on July 26, 2019 at 13:56:12:
GrandPA Love you have the lift chains in the wrong place. Drive up to the flywheel side with the bucket/fork frame, square/parallel to the bale chamber. Center the loader front to back on the wheel. Then take two chains, they need to hook on the pickup side of the baler chamber. Just go under the bale chamber, up by the flywheel, and on most of them you can hook the chain on the bottom plunger slide rail. Hook the top to one side of the loader. Then do the same thing back by the knotters. Lift it this way. 90% of the square balers will balance side to side lifting them this way. You have the weight back close to the tractor. You have the baler turned to where you can back your trailer right under it. Loaded a lot of balers this way.
Even if you passed this one up knowing how to lift one will make the next one easier to load.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.