Posted by 550Doug on August 12, 2019 at 14:07:56 from (198.254.226.165):
In Reply to: Buick died posted by 550Doug on August 11, 2019 at 17:30:00:
Quoting Removed, click Modern View to see
The car did start today but only ran for about 20 seconds and then shut off. I unhooked the MAF sensor and the car restarted and idled real nice for several minutes , then I shut it off. So it seems a new MAF sensor is needed.
The battery is ok at 12.6 volts with the car off and when running the gauge registers 13.3 volts. Is it possible that the faulty MAF sensor could mess with the computer that then messes with the gauges to give that 11.4 v reading yesterday? A couple of weeks ago I had driven about 10 miles and suddenly the gauges went into flicker mode, the battery registered 11.8v and the motor began chugging. I pulled off the road and the gauges stopped flickering but the battery voltage kept changing between 11.8 and 12.4 volts. The drivers power seat no longer worked but the passenger seat worked fine. I continued to my destination, shut the car off, cleaned the battery terminals, fiddled with the wiring under the drivers seat and after sitting for 2 hours the car was working fine, no flickering gauges, normal battery gauge at 13.3 v and driver power seat back in operation. Can all this electrical stuff be related to a failing MAF sensor?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.