Posted by Leroy on August 18, 2019 at 05:55:03 from (96.45.243.241):
In Reply to: Disc grease housing posted by Mustangs on August 17, 2019 at 17:25:09:
That fitting looks like what was in an old very old Massey Harris disk I had. It was 1/4" pipe thread instead of the normal 1/8" pipe thread. You could a couple of years ago buy the 1/4" fittings but you needed a short pipe nipple and a coupler. You could if it is the 1/4" do like above but screw in a 1/4" to 1/8" reducer for a standard fitting. If the 1/8" fitting just get a 1/8" pipe and coupler. The spout on your greae gun is 1/8" pipe. Does the disk have a crank for adjusting gang angle? If yes look on the casting at top where the crank goes through, may be a marknig there. Mine was the Massey Harris and that marking was the M & H put together with the right side of the M being the left side of the H. Just going on what that fitting looks like . The New Idea 3 and 4 bar rakes used one of that style greae fittings. But I have never seen somebody trying to put a lock nut on a grease fitting. It should tighten in good without that lock nut. If problems with tightening just use some locktight.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
