Posted by Bill(Wis) on August 21, 2019 at 14:27:11 from (174.197.21.185):
In Reply to: Subsoiler posted by Joe Styke on August 21, 2019 at 11:54:38:
I have just about every soil type on my farm. I usually pull a Brillion 3 shank subsoiler with a Kubota M6800 4wd with a loader. 62 PTO HP, 57 drawbar HP. 17" deep, no-till points. No coulters. I could pull most of the time in L3 until I added 600 pounds of weight to the rear wheels. Then I could only pull in L2 due to reduced wheel slippage although I was going faster in L3 slipping than I was in L2 not slipping so much. I let the lift arms sway a quite a bit. That way when I hit smaller rocks the shanks will either shift to one side or the other or roll the rock up out of the ground. Then I put the rock in the loader bucket on the next pass. The shanks on this subsoiler are parabolic which pull easier than straight shanks. Non-reset, shear bolt protected. I have never sheared a bolt. When I hit an immovable object, the tractor spins out. When I pull with a 125 HP tractor (my next size up) I can go faster but will shear pins. Not good. I sheared 42 pins one day before I learned to slow down but even then that only helps a little bit. I actually get more work done with the smaller tractor. I also have a 4 shank CaseIH subsoiler, straight shank with coulters, that I pull with a 125 HP tractor. That's the one I use most of the time. Coulters are a must if you have a lot of residue.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
