Posted by Steve@Advance on August 28, 2019 at 19:02:39 from (66.169.147.211):
In Reply to: Needles and seats.... posted by Dave H (MI) on August 28, 2019 at 18:45:54:
If it stopped dripping, I would give it the benefit of the doubt that whatever was causing it has passed.
It only takes a microscopic piece of trash to hold the needle off the seat.
Another trick, drain the carb or run it empty with the fuel valve off. That will let the needle drop, the flood of fuel when the valve is turned on may wash out whatever was in there.
If the flooding continues, then go back in. Check the float, give it the "shake test" for fuel inside one of the pontoons. Check the float level. Clean the seat with a Q tip. Incpect the needle with a magnifying glass. With the upper housing inverted, the weight of the float resting on the needle, suck on the fuel fitting, put your tongue over the hole. It should hold vacuum. If not, there is a leak somewhere.
When I get the carb back on, I like to flush the line with gas before connecting it. Turn on the fuel valve, let gas run through the line as it is connected. This is especially important on a working tractor that is less than sanitary, or one that the fitting is difficult to see or connect.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
