Posted by farmallhal on August 29, 2019 at 08:29:36 from (174.30.124.33):
I seem to be having a lot of trouble recently in getting a hand grease gun to start pumping grease following a cartridge change. I can pump it 200 times or more and no grease comes out the gun. Before those pre-packed cartridges became the norm and we hand filled the gun from a 5 gallon bucket of grease I don't recall any problems but that was decades ago in my youth. I generally have found that beating the end of the grease gun on a piece of wood shakes it loose so it can be pumped out but that doesn't seem to work on this one. I presently have it setting vertically in direct sunshine thinking maybe the grease in the cartridge will flow a little better but it is presently in the 70's now but headed to the upper 80's later today. Does anyone have a solution that seems to work to get the grease flowing after a cartridge change?? This is a Lincoln brand name grease gun but still could be something from across the big pond to our west. Thanks for any suggestions which might resolve this issue, Hal.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
