Tractor Talk Discussion Board |
Re: Humorous screwups
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DP on December 29, 2001 at 21:44:38 from (12.158.133.149):
In Reply to: Humorous screwups posted by JoeK on December 29, 2001 at 12:37:22:
I've done so many dumb things, I'm not even going to go there!! Do have a mishap to report here though. Was back probably 25 years ago, had the 49 John Deere G parked at the other place with the three bottom mounted plow on it. Had finished plowing one evening, and it rained that night, so didn't go after it for a couple days. Had a little time before dinner one day so had my wife take me to get it. Figured by the time I'd drive it 10 miles home dinner would be almost ready. I jumped up on the tractor, hit the starter and she came to life. I hit the powr-trol lever to raise the plow and without even looking back was in gear and headed for the road. All was going well and I was a few miles toward home when I slowed down for a short plank bridge probably twice the length of the tractor and plow. It was a little rough going on it, and apparently the plow hadn't raised to the full raised position, because I heard and felt something, and when I turned and looked, the back bottom of the plow had caught the first plank, and it and everyone all the way across the bridge were standing up on edge. I stopped and got my trusty claw hammer out and spent the next 45 minutes getting them layed back down. I didn't want to leave to get help for fear someone would come over the hill and hit it. It was too much a task for the little hammer, but I did get them back flat again. Went home and called the county and told them they had a bridge needing repaired. Only damage on my end was the beam to the back bottom for some reason was in two pieces.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|