I don't care what length the chains are as long as they aren't dragging on the ground. The breakaway tether should be attached to the trailer hitch frame or the vehicle frame, NOT to the ball insert if it's a recv'r hitch! Those inserts can come out and then you have no breakaway if the tether is hooked to the hitch. The tether should be short enough to activate (pop the plug) BEFORE the chains would come tight in the event the trailer becomes unhitched. I've tested a lot of breakaways and I have yet to see one that will lock the brakes on even an unloaded trailer. I'm telling it like we were taught in DOT school, there may be State laws that spell it out differently. As we were told, the breakaway should activate just before the chains come tight even if the regular service brakes remain attached and working. They were supposed to keep the unhitched trailer now being dragged behind you more or less straight and not whipping around, maybe busting the chains and it was to help keep the trailer from rear ending you...which it will do if there are no brakes and you slam on the towing vehicles brakes.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
