Posted by Bruce from Can. on September 18, 2019 at 06:59:34 from (74.12.72.61):
In Reply to: Re: Swathing grain posted by caterpillar guy on September 18, 2019 at 05:32:45:
My grain is a multi purpose crop for me. I need the straw for bedding, the grain I grind for heifer feed, and it acts as a cover crop for new hay seeds. Kind of a three in one deal. Many times the hay that is under seeded will start to grow too fast, if the grain gets off to a slow start, and weeds will also grow right along with the hay. When this occurs, cutting the grain crop with a direct cut head is a nightmare. The green stuff will plug the cylinder or rotor on any combine. So the head has to be held up high, just taking the grain and leaving the straw behind. If the crop is like this, full of green hay and weeds, you can cut it with a swather and the green stuff will dry, and go right through the combine no problem. The crop in my picture would direct cut with ease, but I don’t have a direct cut head for my old 851 MF pull type combine. Last year there were several farmers that couldn’t cut their grain because we got too much rain in August, and green stuff took over, some just cut it with the mower and baled the mess. I was able to harvest the grain and bale the straw. Even did some custom swathing for some neighbors that didn’t have swathers, so they could get their crop off. This sort of conditions happens probably every other year to some degree. Most of us are livestock farmers and need both the straw and the grain. Hope this explains the how and why’s.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
