Posted by JD Seller on September 18, 2019 at 18:31:28 from (208.126.198.213):
In Reply to: Re: Setting posts posted by Grandpa love on September 18, 2019 at 06:03:24:
That is all the deeper you set posts???? I set line post 3-4 foot and corners 4-5 foot.
I drive my field fence posts. My driver has a small 4 inch auger that you drill a pilot hole with and then drive the post into it. Nothing to back fill and still have a straight post.
On large corner posts or ones that have to be an exact distance, I drill holes but back fill with clean 3/4 stone. In dry conditions like you have the side walls are like concrete. That stone will make the post darn near as tight as concrete. I like doing them that way as the posts seem to last longer here.
I have a Shaver HD-12D driver with the pilot hole auger. It was not cheap but I have built miles of fence with it.
Here is a driver like mine. You can see the auger swung out of the way to drive.
Here you can see the auger in use.
Here is some of my fence. Not as good as looking as yours though.
P.S. I would just DIE in your heat and humidity!!!! LOL I am built for the COLD. I will take zero any day over 80-90.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
