Posted by Jon f mn on September 22, 2019 at 16:49:08 from (174.219.8.134):
Got back at the baler needles today. Had the hardest two left because they were bent the worst and missing pieces. Had to form a piece of 3/4"x1" bar. A little heat and my rr track and plastic hammer took care of that.
After it was shaped I welded them in just like before.
After that I had to figure out how to cut the channel down the back for the twine.
Thought I would try to dig it out with my air hammer and the tin cutting hammer. Thought that anvil hanging down might be pretty close to what was needed.
Worked pretty good too. Cut the trench with the air hammer, then just some cleanup with the die grinder.
Also had to do some repair to the tips where the twine feeds through, was worn way past the wear pins. So I welded those up and drilled for new pins. I used 3/8 hard bolts, only the smooth shank, and lock tighted them in.
After that I did some final shaping and grinding to make them smooth and nice. They are not perfect, bit I think they will work
Even got them all boxes and ready for shipping back to Idaho.
Was a fun job and a real challenge, I'm kinda excited to see if they work.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.