Posted by Steve@Advance on September 25, 2019 at 18:42:13 from (66.169.147.211):
In Reply to: 460 farmall posted by 460 farmall on September 25, 2019 at 16:44:41:
Put your test light or voltmeter on the coil terminal connected to the distributor, ground the other lead.
Open the distributor and watch the points.
With the ignition on, points open, should have approximately 12v or a bright test light.
If no voltage, move the test lead to the ignition side of the coil. If no voltage, keep tracing back toward the ignition switch until you find the break.
If voltage on the ignition side, but not on the distributor side, the points, condenser, or wire is shorted to ground.
If voltage is present on the distributor side coil terminal, turn the engine until thepoints close. Voltage should drop to zero.
If voltage does not drop, the points did not make contact, the wire from the coil to the distributor is open, or the distributor housing is not grounded.
If the voltage did drop, but still no spark when the points open, repeat the voltage test back toward the ignition switch with the points closed (circuit under load). If there is a resistor ahead of the coil, points closed, should have about 6v or dim test light at the coil, 12v ahead of the resistor.
Be careful load testing, don't want to overheat the coil or points. Test quickly, if the coil gets uncomfortable to touch, give it a cool down break.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.