The three point arms may need to be up or down, and there is nothing in the picture you asked about on the arms. Interferences are a reason I mentioned possibly having the tiedowns under the tractor. The reality on anything you are securing is; you need to physically be hands on with it on the trailer to see where you can connect, it changes with trailers due to different anchor points and positioning on the trailer. Cross chained, pulling down at about a 45 degree angle with 4 chains is the generally accepted basic starting point for hauling rubber tired equipment in my experience. Additional chains, and straps where appropriate, added as needed to meet weight and size regulations. A tractor as new as this one may have tiedown info in the operator's manual and/or may have a tie down kit option for it which might be handy to add if it was going to be transported regularly.
Over the years I have helped drivers secure many loads and will say I have seen the same piece of equipment chained down differently by different drivers and they all got through DOT checks with no problem. Outside of recommending you replace your bolts with hooks, I expect you will likely get by for what, and where, you are hauling without a problem if you tie down as you have been.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
