Posted by keith True on November 09, 2019 at 05:19:06 from (73.68.29.112):
In Reply to: Overhead Powerlines posted by stroby on November 09, 2019 at 04:51:42:
I've seen it happen with a dump trailer.The driver knew what he was doing,he was dumping on a project for an industrial park under some high tension lines.He was a lot more than six feet from them,and dumped with no problem.He called me on the radio,(I was the mechanic)and told me to get a tire ready because he had just blown one.i was headed for the tire shed when he called back and said he lost another one.OK,not unusual to lose the mate to it when one blows and the mate takes all the weight.It wasn't the mate.Then the boss got on the radio and asked him if he was near the power lines when he dumped.He was,the boss said get out a set of tires and some bearings.He knew exactly what happened.It was VERY hot and humid that day,and the current jumping through the tires has turned the steel cords into hot wires like in a toaster.When he ran the four miles back to the shop he had three tires out of eight still holding air.I didn't think such a thing could happen,but all the older drivers that had paved with dump trailers had all experienced it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.