Posted by kcm.MN on November 25, 2019 at 20:24:56 from (174.219.0.56):
In Reply to: Leveling a floor posted by 37chief on November 25, 2019 at 19:01:26:
I made a water level using an empty laundry detergent jug and a 20' length of clear tubing. Tubing fit snug near bottom of jug and was sealed with silicone, so had to be fairly careful. Could sit the jug in the middle of a room and find the high and low spots without moving it. If you move it, you screw things up. Any vertical adjustment up or down with the water will change everything, so either place it in a central location, or break a large job into smaller components....or get a longer tube!
How to use:
1. Place water source in central location
2. Have a piece of masking or duct tape as marker near the end of tubing.
3. Measure from each desired location.
Do not adjust tape, and always bring water level to either the top edge or bottom edge of tape. That will be your level line. Measure any variance with a tape measure, ruler, yard stick or, for anyone who remembers what they are, a story stick. I would also recommend adding just a couple drops of Dawn dish soap, clear if you can find it. The soap breaks surface tension and helps the water equalize a little faster. Add soap to water before adding water to jug to ensure equal distribution.
Also, is best to use 3/8" tubing or larger. I used 1/4" and it took a while for the water to equalize through the 20' of length. The longer the tube, the more time required for equalization.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
