Posted by 4wdtom on November 28, 2019 at 07:59:20 from (71.161.236.135):
In Reply to: Allis will not start posted by FtInn Farmer on November 27, 2019 at 16:41:26:
If the ideas you have received don't help it may be a more serious magneto problem. I was having starting problems with my AC WD this summer. It would run fine once running but would not start. Finally thought the spark was intermittent and took the magneto to the shop that does them around here. He cleaned the points, adjusted them, tried a condenser and different cap and rotor, no improvement so I left it for further work. Turned out the magnet would not hold it's magnetism. He installed a NOS magnet and it has been like new. Said it is rare for the magnet to fail in a FM magneto. For those lucky enough to be near this shop it is Mark's Magneto in Colchester CT. Highly recommended by those in this area.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
