Start with verifying the firing order, which is 1243 clockwise.
If in doubt about the timing, static time it.
Remove the #1 plug, hold your finger over the plug hole, turn the engine until you feel compression, keep turning until the piston is at TDC, or slightly before.
The rotor should now be pointing at #1 cap terminal.
Loosen the distributor clamp, rotate the housing clockwise, then with the ignition on, rotate it CCW until the coil fires. You may have to do this several times and with some speed to get the ignition to trigger, but the goal is to stop turning the housing when it fires. That will put it close enough to start.
A quick check of the engine integrity: Pull and ground the coil wire. Hold your hand tightly over the air inlet of the carb. Crank the engine through. You should get a strong vacuum on your hand, and your hand wet with gas.
Little or no vacuum, or pulsing vacuum/blowing back indicates valve or compression problems. No gas indicates lack of fuel delivery.
Have you checked the oil level? If over full it may be gas contaminated, especially if the carb was flooding. The rings may also be washed down. A squirt of oil in each cylinder will raise the compression if they are washed down.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
