Posted by Zeke Boniface on December 12, 2019 at 10:06:53 from (74.106.194.66):
My dad owned a couple 6 amp Schauer battery chargers in the 60's and 70's. When a battery wasn't badly discharged, those chargers would begin charging at four amps or so. When the battery was seriously discharged, the ammeter would peg for a few seconds, the charger would shut itself off for a bit, then the cycle would repeat. It took some doing to get a really dead battery to charge.
Today I have several vintage chargers of the same type, and none of them will put more than a couple amps into a battery regardless of charge. I have a ten year old Schumacker that isn't much better. (I didn't have a Fluke clamp meter back in the day, but now it isn't hard to confirm the battery's state of charge and the output of the charger.) The charger ammeter will never peg when connected to a battery, but will readily peg when the charger clamps are flashed together.
Any of my old chargers will fully charge a battery sooner or later.
As we speak, one of them is charging a half discharged battery at a blazing 1 amp.
I have a bunch of batteries in a bunch of tractors, trucks, and dozers, and 2 amps is about the most to expect from any charger on any battery.
Interestingly, my 8N with 12 volt alternator and ammeter seems to charge its battery normally; but none of the chargers will. Ideas?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
