Posted by Steve@Advance on December 12, 2019 at 19:32:23 from (66.169.147.211):
In Reply to: Re: Help with onan posted by Khemo on December 12, 2019 at 18:53:37:
It's rare for a working carb to go bad beyond repair.
Even if you can't find a kit they can usually be eased apart and cleaned if needed. The worst thing for them is sitting with ethanol gas in the bowl, or water contamination.
I don't know what the carb looks like on that engine, but if you do need to substitute a different carb, there will likely be a name brand on it, start there looking at pictures, try to get as close as possible to the original dimensions and match the displacement/HP as close as possible. Pay attention to the fuel fitting location, choke linkage, and throttle linkage. Throttle linkage is very important on a governed engine, it must match the travel and operating direction of the existing governor closely.
Before investing in anything for the other engine, might switch the carb off the running engine to see if it will run and how it sounds.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
