Posted by Goose on December 24, 2019 at 19:51:07 from (166.181.85.3):
In Reply to: Christmas Eve 1970 posted by muleboss on December 24, 2019 at 15:24:20:
Of the ten years I spent in the Marine Corps, I was home for Christmas once.
Can't really remember where all I was, but I know I spent one deployed to a Nationalist Chinese Air Force Base on Taiwan. I don't remember the Christmas, but I'll never forget the New Year's Eve.
The officers and Staff NCO's from our unit were invited to a New Years Eve party at the Nationalist Chinese Air Force Officer's Club in Ping Tung. The Chinese celebrate New Years with fireworks, and there were so many fireworks going off right in the club that they had to stop the dance several times to sweep the debris from fireworks off of the dance floor.
At one point, I went a block or two down the street to reload on fireworks, and from a block away it sounded like there was a full scale firefight going on in the club.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
