Posted by John T on January 03, 2020 at 05:00:25 from (107.77.215.178):
In Reply to: Melted fuse posted by ztw2009 on January 02, 2020 at 20:19:58:
When you get resistance in any connections, including blade fuses or the fuse holders, the I Squared R heat energy becomes significant and can melt plastic as shown in your pictures. Older components including fuse holders and even the fuse contacts themselves can develop oxidation and carbon IE resistance. Having owned RV's for 49 years I've seen fan or furnace blower motors begin to draw excess current (maybe bushings maybe electrical) even if not enough to blow fuse and if so they need replaced.
Its a job to replace that entire fuse assembly but from the looks of it that may be required. If not get into that bad circuit (ahead of and BEFORE the assembly) and patch a new fuse and holder to it. It would take an ammeter to measure current draw of the fan motor, but there's a chance it may be excessive. If not then resistance (oxidation or carbon) must have been the cause.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.