Posted by Billy NY on January 06, 2020 at 07:21:02 from (74.70.87.149):
In Reply to: Re: Driveway culvert posted by Dave41A on January 05, 2020 at 18:09:25:
Some confusion here, clean crushed stone will not compact, no range of different aggregate sizes within it. Gravel without too much really large aggregate, crushed stone, crusher run, whatever they call it where you are with the array of aggregate sieve sizes from fines to say 3/4" at optimum moisture content will compact sufficiently.
What showcrop is talking about is filling the depth of the hole in increments, say 12" lifts, compacting and an inspector would test each lift with a device such as a Troxler nuclear density meter.
If you have decent gravel or crushed stone material, and there is no other issue, placing and compacting with various means should make the difference. What retains the cover over the pipe one the ends, is it stable or not retained, sloped at correct angle of repose is the only thing I can think of unless the subgrade under the pipe is unstable, and I have seen that happen with sanitary sewer lines. Some variables to consider, but nothing complicated with the right material and say a plate compactor or even running over with the tires of a tractor, just do so in smaller lifts if need be.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.