Posted by Northvale PA on January 18, 2020 at 14:56:05 from (24.112.141.217):
About every 2 or 3 years I spread damp lime on my hay fields, normally early November. I had 60 tons brought in right before thanksgiving. But the spreader I borrow was not available for 2 more weeks. I put tarps over the piles and tied them down to posts but the wind blew them off. After about 2” of rain the piles froze up in early December. I started spreading right before Christmas. Except for frozen chunks, things went ok initially. But then the piles started thawing and the moisture migrated and then it became like scooping and spreading tooth paste. I finally finished up yesterday. A 2 day job took about 5. Day 1. The neighbor’s white chicken, apparently. Day 2. Frozen chunks about 5” thick. Stuff in the middle spreadable Trying to get 1 more spreadable load before the pile freezes up over night Everything thawed out here over last 2 weeks. The toothpaste is done with. Happy new year.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
