In 1964 I was on the school bus (the bus and driver, Klem, lived 2 miles away) in the seat behind Klem. We were in a snow drift about 14 inches deep and getting stuck. It was a 1948 Diamond T, and we were trying to back out of the drift, I heard a bit of added noise from the engine. As I watched the gauges, I noted a wiggle in the oil pressure that was in sync with the RPM. We struggled in the drift for about 5 minutes, going forward and back maybe 50 feet each time. The engine noise turned into a knock, and the needle on the gauge dropped to 20 PSI each revolution, from the 40 psi that was normal. I asked Klem if we were going to loose the engine. He said we already did, but he was going to keep it alive so we stayed warm. Andy (a school mate and friend of mine) had just been picked up about 300 yards prior, and he had a dad at home, and a Farmall M with plow, heat Houser, and chains. Klem asked andy to trudge back and ask for help. We were pulled backwards to Andy's house, where we stayed until a different bus came and took us all home. I do not care if the gauge wears out, I remember that indication of pressure variation to this day, and find that the engine is more valuable than the gauge. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
