Posted by Donald Lehman on February 27, 2020 at 09:34:43 from (74.78.242.235):
In Reply to: Re: Maple syrup posted by caterpillar guy on February 27, 2020 at 05:35:44:
If you use tubing, you only have to use a minimum of collection points and quality of the woods roads in not so much a factor. We find that the deer don't have any problems negotiating woods areas criss-crossed with tubing. We have found that deer who were smart enough to push bucket covers off and drink sap will eventually figure out that if they chew through the tubing they can still get to drink sap. This has not been a real problem, but occasionally you will encounter a smart alecky deer who has figured it out. We have had that happen twice in four or five years. We had one last year who kept chewing the tubing in the same spot for several days. I finally had enough connectors put in that he couldn't chew through them any more and left the line alone. Why it didn't just move down the line two feet an chew it through again, I don't know. Maybe he just decided to go across the fence line and pester the nieghbor instead. I am paying between $37 and $45 dollars per 500 ft roll of 3/16 tubing. I am assuming you won't use a vacuum pump on the tubing. Keep your tubing small enough that it runs full of sap thus creating it's own vaccum. We are running as many as 300 to 400 taps on 3/16 line and getting enough vacuum to get 10% to 15% more sap compared to when those trees were on buckets. We have as few as 27 taps on on line and we are still getting enough vacuum to yield more sap than we did when they were on buckets. We only have about 5-6 feet of drop on that 27 taps. The biggest headache with tubing is making sure you have blowdowns cleared off the tubing before the snow packs down the deadfall and then the tubing is underneath a foot of snow with a stinking branch over the top of the tubing. That's a real pain.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.